Property Lower-ground-floor (walkout basement) flat, solid rendered masonry
Location Bayswater, London W2
Survey Full damp survey
Client Homeowner

The problem

The bedroom sits partly under the building’s entrance, and shares a wall with a storage room that runs under the pavement and has always been damp. That shared wall had blown plaster, peeling paint, brown staining and a dark, possibly rotten edge along the skirting, and a double socket had started pulling away from the wall. Water had come into the bedroom from the entrance area before, and work had been done there. The owner wanted to know the cause, whether it was limited to that wall, and how to fix it.

What our surveyor found

  • Bedroom: significant damp in an earth-retaining wall. Raised moisture in the timber, visible water damage and signs of moisture trapped behind the dry lining. This is a wall holding back the ground under the entrance and pavement, so it’s exposed to below-ground moisture.
  • Not condensation. The bedroom was cool (16°C, dew point about 9.3°C), which adds some condensation risk, but the pattern of damage couldn’t be explained by condensation alone.
  • Boiler unlikely to be the cause. The boiler is in the bedroom, so we checked it. It was holding about 1 bar, and nothing linked it to the wet wall.
  • Ceiling: raised readings where an existing Type C waterproofing membrane may not fully cover the ceiling-to-wall junctions.
  • Outside: defective render, and render bridging the damp-proof course at low level.
  • Bathroom: moisture at the base of the walls around the bath, and weak extraction.

Our conclusion

The main problem wasn’t rising damp or condensation. Below-ground walls next to the entrance and the under-pavement store aren’t adequately waterproofed, so ground and rain water are getting through. The problem is wider than one wall: the ceiling junctions, external render and bathroom each need attention too.

What we recommended

  1. Strip back the affected dry lining and skirting to expose the masonry, check the hidden timber and see what waterproofing (if any) is behind it.
  2. Get a waterproofing designer to specify a solution for the earth-retaining walls. A properly designed Type C cavity drain membrane is the preferred option where water can be drained away.
  3. Check the ceiling membrane junctions and the low wall by the rear door, where the ground level may be bridging the defences.
  4. Repair the external render and remove the low-level render bridging.
  5. Test the bath seals, waste and plumbing, and upgrade the bathroom extraction.
  6. Only redecorate once the source is fixed and the wall has dried out.

The takeaway

In basement and lower-ground flats, damp on a wall that backs onto a pavement, steps or a vault is usually a waterproofing problem, not rising damp. Injecting a chemical damp-proof course or replastering won’t stop it. Find out which walls are holding back the ground before you spend money on treatment.

Damp in a basement or lower-ground flat? Book an independent damp survey or waterproofing survey and get a clear diagnosis before you pay for treatment. Get a free quote.

Related Posts

Basement of a house being damp proofed
Case Study: Basement Water Ingress at a Commercial Building in Clerkenwell (EC1)

Prospective tenants needed to know if a Clerkenwell basement would stay dry before signing a lease. Here is what our survey found and the costed Read more

Case Study: Fungus Growing Behind Skirting Boards in Richmond (TW9)

Mushrooms appeared between the floor and skirting in a Richmond kitchen with underfloor heating. Here is how our survey narrowed down the likely hidden leak.

Case Study: Drain Smell in a Fulham Flat That Wouldn’t Go Away After a Leak Was Fixed (W6)

A tenant in a Fulham flat still had a drain smell in her bedroom after the leak upstairs was repaired. Here is what our surveyor Read more